Prior to Installation
- Concrete contact surfaces must be cleaned of all oil,
grease and dust. Remove paper backing from adhesive and
carefully stick Slab Saver Shoe in desired location (Max.
800mm centres) and apply Min. 50kgs downward pressure
and rotate on Shoe.Important Note: If the Shoe de-bonds
with the concrete surface - DO NOT REUSE.
|
Insert "Tail" of Bracket into slab
Saver Shoe
Snap Bracket down in place
Finally, place wood screws into the Fo
|
 Remove screws from Bracket/Form Board
Then pull Bracket Upward to Reuse
Shoe can remain in place until Board is stripped
|
 Place small pry bar under tail of Slab Saver
Shoe and lever upward. Tape will de-bond with concrete surface.
A razor blade scraper can be used to remove any adhesive left
on slab.
|
